Jewellery Know How - How to Make a Wrapped Loop

For a neat and secure way of linking components together, the wrapped loop will give your handmade jewellery a professional finish. Wrapped loops are especially useful when using heavier beads such as lampwork beads. For a more organic look or homespun feel, you can make the wraps a little messy to add some visual interest.

You'll need the following tools:
flat nose pliers
round nose pliers
flush cutters
crimping tool or chain nose pliers

Cut a piece of wire measuring 7.5cm (3"). Grip the wire with flat nose pliers at the 3cm (1 1/4") mark.

Bend the wire at a 90° angle.

Remove the flat nose pliers and place round nose pliers in the neck of the bend. Grip the tail of the wire with your fingers and wrap it around the top jaw of the pliers to form a loop.

Keep wrapping the wire around the jaws until the loop is complete. The wire should now cross in front of the neck and sit perpendicular to it.

Remove the round nose pliers and hold the loop in the jaws of the flat nose pliers. Using your fingers, wrap the tail neatly around the neck of the wire two or three times. If you find it too difficult with your fingers, use a pair of chain nose pliers.

Trim  the tail away as close to the neck as you can.

Place the wrapped neck in the top hole of the crimping pliers and gently press the cut edge of the wire against the neck. Chain nose pliers can be used to do this but crimping pliers will round the cut wire better.

The finished wrapped loop should look something like this.

Pin this technique!

'Til next time....

If you can't get enough of My Tutorials and you want even more inspiration, click here to find my books and printable pdfs